steverowe58
Member
Hi purchased a Tornado R9.
On start-up I'm getting CPU Fan Error! Press F1 to Run Setup which takes me through to the BIOS
Here I see a lot of info that is little out my area....
I can see under Fan Profile CPU Fan is reading N/A, there are two other fans giving an RPM in this section.
I've managed to get through the BIOS by exiting without saving and all appears normal so far. I've windows set-up and dowdloads whirring etc. Importantly there's no smoke.
When I change the profile on DOCP from the current settings to default and back again I get a message about "performance is usually best when memory clock: etc etcetc"
So do I have a problem?
Can I expect to have to navigate through the BIOS on this kind of advanced machine?
On start-up I'm getting CPU Fan Error! Press F1 to Run Setup which takes me through to the BIOS
Here I see a lot of info that is little out my area....
I can see under Fan Profile CPU Fan is reading N/A, there are two other fans giving an RPM in this section.
I've managed to get through the BIOS by exiting without saving and all appears normal so far. I've windows set-up and dowdloads whirring etc. Importantly there's no smoke.
When I change the profile on DOCP from the current settings to default and back again I get a message about "performance is usually best when memory clock: etc etcetc"
So do I have a problem?
Can I expect to have to navigate through the BIOS on this kind of advanced machine?